Riven oak laths are supplied in bundles containing 4' (1.22m) lengths. They are used to build traditional lath and plaster walls, they can also be used to replace laths in damaged areas of an old wall. See more Timber is naturally hand split into randomly shaped laths and cut roughly to length. This produces a coarse, uneven surface providing the … See more Timber laths are an ideal background for lime plaster, they provide a good key and form a gauge that keeps the plaster relatively even. They … See more Timber laths must be completely saturated when fixed, they will shrink and pull tight as they dry out. This requires the lengths are fully immersed in water for at least 7 days (although longer is better) up until the point of … See more The laths are fixed horizontally to the wall or studs, typically with 10mm spacing between them. The gaps between must not exceed twice the … See more WebInstruction: Replace lath and plaster ceiling and wall, run cornice detail. Material: Sand and lime, riven oak lath. Our task here was to remove unsafe lath and plaster celing and re-install.The ceiling was a portico of a Crown Court which was 30ft high. We had to implement and adhere to strict health and safety rules as the court was still in ...
Oak Lath - Coyletimber Ltd
WebA bundle of fifty 4ft sawn oak laths (200 linear ft). Ideal for lath and plaster work where a hardwood has been specified and riven is not required. Our sustainably sourced laths come from UK managed woodlands. One bundle covers approximately 2.5m2 of wall. WebLath provides an ideal background for lime plasters as it can be wetted down which helps the slower drying of the plaster. Laths come in both Riven and Sawn options. Riven laths … tamscot
Riven Oak Laths - Lime
WebRiven Oak Lath: The laths are split by hand (hence the cost) using traditional methods such as mauls and froes or riving knives along the length of the grain. The result is a thin strip … WebThe mix used is usually one part lime putty to two and a half parts of coarse, sharp, well-graded sand. It also contains animal hair used to bind the material especially when applying onto timber lath. While still wet, the surface should be scratched with a three pronged lath scratcher or a single pointed lath. WebThe purpose of the riven lath, as opposed to sawn lath, is to provide extra grab for the fibrous lime Plaster. The splitting follows the grain down the wood and leaves an uneven reeded surface. This means that the plaster will stick and grip, even on ceilings. tams crossword clue